Electronics Forum | Mon Oct 15 11:27:48 EDT 2001 | rob_thomas
Hello all, Does anyone have any experience using solder quick preforms for ball attach on Flex? Thanks, Rob
Electronics Forum | Thu Mar 05 16:25:27 EST 1998 | Brian Stumm @ ETS
| I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. | Is it possible to reflow without damaging the tape. Any suggestions? Do you have a profiler for your reflow oven?
Electronics Forum | Tue Mar 21 17:44:45 EST 2006 | omar_verdugo
hi all, could someone have an idea, would it be the best method to attach a flex cable to a pcb. right now, we are using a hot bar to solder the flex to the pcb, but we are having troubles with this method. the process is no regular all the time a
Electronics Forum | Wed Dec 22 18:09:07 EST 2004 | kmorris
At a previous job I had been taught that when reflow soldering polyimide flex circuits, it was necessary to pre-bake them before reflow soldering to prevent delamination. Our procedures said that there must be a 1hr bake prior to reflow, and the flex
Electronics Forum | Tue Mar 21 19:34:32 EST 2006 | Tom Smykowski
Omar: I dealt with this so called "hot bar" process also, and you're right; it's neither reliable nor repeatable. The goal was to attach a flex LCD display to another flex circuit. The flex LCD was constructed of resin and conductive silver particl
Electronics Forum | Fri May 12 08:58:04 EDT 2023 | tommy_magyar
This is a defect in all IPC classes. Solder has not wetted to the land where solder is required.
Electronics Forum | Sat Jan 21 13:49:14 EST 2023 | pcbsino
perhaps we can help you for this SMT and THT part soldering problem, better not bend it not too hard. Electronic manufacturing pcbsino.com
Electronics Forum | Fri May 26 04:58:19 EDT 2023 | auriga2001
I agree with the two other replies. Left alone, it is a defect. If it's just excess adhesive or coating, you can use IPC-7711/7721 'Rework, Modification and Repair of Electronic Assemblies' for guidance on removing. Section 2.3.1 explains how to te
Electronics Forum | Fri Mar 17 14:59:50 EDT 2023 | proceng1
OK, does your axis screw have the flex coupler or the magnetic coupler? Which axis is it? Did you turn off soft limits? If it's out of range, soft limits won't let it move by controls. I need to know which axis before I can get too far into this. I
Electronics Forum | Tue Sep 06 10:20:33 EDT 2005 | slthomas
I love these stories. At my previous employer we experienced intermittent failures on an audio microprocessor assembly being used on a *new* product. This board had numerous microprocessors and complex firmware aboard. They discovered one PLCC on
