Electronics Forum | Tue May 26 11:56:30 EDT 2009 | mmjm_1099
I also use Flexa but we use QP3 and our vision number is 20. I would feel they are comparable libriares.
Electronics Forum | Mon May 25 20:21:47 EDT 2009 | dcell_1t
Hi there: I'm having trouble to assign an adequate vision Type to dpak components in Fuji Flexa (placed by an IP3, SMD3 vision system). Currently we're using 254 but accuracy is reduced and also can be placed backwards (yes, I know... supplier packag
Electronics Forum | Tue Oct 11 07:54:26 EDT 2005 | Mark
254 (odd parts) ........ go into the Flexa program and go over the vision number and click on it and than hit F1 for a list of numbers.
Electronics Forum | Mon Oct 10 22:29:04 EDT 2005 | matjen
We are trying to place a connector with a IP2 but every vision # we have tried will not place the connector, If anyone has any flexa experience or knows a vision # that we can enter in that will place a odd shaped connector please let us know, Th
Electronics Forum | Fri Oct 17 20:26:21 EDT 2008 | diesel_1t
If is IP-1, is using SMD2 vision instead of SMD3 (CPIV-IP3, CP6,7, etc) if so, you must use Vision Number instead of Vision type... if you're using fuji flexa just press F1 on vision number and you will se most common vision numbers depending on shap
Electronics Forum | Mon Jun 01 05:23:40 EDT 2009 | kircchoffs
hi manuel, you can try vision 180 frontlight. treat DPAK as two leaded part. assign the the upper and lower leads at 1 and 3.
Electronics Forum | Wed May 27 18:19:58 EDT 2009 | dcell_1t
yesterday I tried with vision type 20, just defined the two pair of leads and error 1CA14003 came up, on flexa error help says the following: Cause: The Vision_type in part data is expressed using hexadecimal notation (??). If ?? equals 0A, 0B, 0C,
Electronics Forum | Tue Dec 06 19:44:10 EST 2011 | comando
Hello every one! I need help with a misaligned theta at plcc44, the machine is a IP3 smd3, firmware 2.99, vision card 4400 and both camera type YD2048N on label but in Proper data is set 2 (I don't know if this is right) we use Fuji flexa, Back Lig
Electronics Forum | Wed May 27 16:39:33 EDT 2009 | rmitchell
Hi, I think vision 20 will work as well. If not we have used 100 or 105. Have you tried placing the part with the machine trace on? If so is it finding all the leads? any error codes? If you are defining the leads in the EL lead data I would not d
Electronics Forum | Thu May 27 18:40:02 EDT 2010 | dcell_1t
Hi. I'm trying to develop a shape to place a QFN at a CP6, I'm using FujiFlexa. We have never had a shape for this particular component, we only draw as a rectangle and put a rectangle vision No (10 in this case) but we're scarifying accuracy. is th
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
