Electronics Forum | Tue Jan 13 15:16:12 EST 2004 | drewhmi
A small benchtop system uses a mask, tooled for your part, to arrange the solder spheres onto the BGA, after it has had the excess solder heat-vacuumed off and a new layer of flux applied. The spheres are poured into the cavity, excess decanted off.
Electronics Forum | Tue Jan 13 16:01:06 EST 2004 | russ
I believe that solder paste will need to be applied to this part. I have re-balled these in the past in a low volume situation and here is what I did and there appears to be no adverse effects to the component. Get a stencil (I use 8 mil for .032"
Electronics Forum | Thu Jul 22 21:48:21 EDT 1999 | kyung sam park
Does anyone have any experiences with bga reballing. When I had reworked failed bga part with new part It was good. So I tried to reball bga detached but failed . I guess the cause of fail is thermal shock. IS IT OK TO REBALL BGA PARTS DETACHED ?
Electronics Forum | Thu Jul 22 22:57:14 EDT 1999 | Earl Moon
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Mon Jul 26 15:09:31 EDT 1999 | APE South
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Mon Jul 26 15:25:27 EDT 1999 | APE South, Jack Reed, Asian Sales Administrator
Dear Mr. Park, Ahn yahn haseo and good day to you. If you are currently in Korea, APE has a direct representative there, Omni-Create in Seoul who can give you full information on BGA reball kits available. Essentially, reball kits are custom made t
Electronics Forum | Wed Jul 22 08:10:24 EDT 2009 | olsa
Hello, this is my first question. More than 10 years my job was mobile phones repair, and for BGA repairing proces I used special template stencil, soldering paste and flux. Right now my job is notebook repair, and I'm interested about reballing of
Electronics Forum | Wed Oct 23 08:40:20 EDT 2002 | davef
Yer not making this easy. What kind of flux? If no-clean flux, what controls are you using to assure you are: * Applying the correct amount of flux? * Properly activating the flux? If water washable flux, talk to us about your cleaning methods and
Electronics Forum | Wed Oct 23 07:32:18 EDT 2002 | Yannick
Sorry, the layer is made of flux.
Electronics Forum | Thu Oct 24 10:05:59 EDT 2002 | Yannick
I don't know the name of the flux. but is a no-clean solder paste.
