Electronics Forum | Tue Jan 13 15:16:12 EST 2004 | drewhmi
A small benchtop system uses a mask, tooled for your part, to arrange the solder spheres onto the BGA, after it has had the excess solder heat-vacuumed off and a new layer of flux applied. The spheres are poured into the cavity, excess decanted off.
Electronics Forum | Tue Jan 13 16:01:06 EST 2004 | russ
I believe that solder paste will need to be applied to this part. I have re-balled these in the past in a low volume situation and here is what I did and there appears to be no adverse effects to the component. Get a stencil (I use 8 mil for .032"
Electronics Forum | Thu Jul 22 21:48:21 EDT 1999 | kyung sam park
Does anyone have any experiences with bga reballing. When I had reworked failed bga part with new part It was good. So I tried to reball bga detached but failed . I guess the cause of fail is thermal shock. IS IT OK TO REBALL BGA PARTS DETACHED ?
Electronics Forum | Thu Jul 22 22:57:14 EDT 1999 | Earl Moon
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Mon Jul 26 15:09:31 EDT 1999 | APE South
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Mon Jul 26 15:25:27 EDT 1999 | APE South, Jack Reed, Asian Sales Administrator
Dear Mr. Park, Ahn yahn haseo and good day to you. If you are currently in Korea, APE has a direct representative there, Omni-Create in Seoul who can give you full information on BGA reball kits available. Essentially, reball kits are custom made t
Electronics Forum | Wed Jul 22 08:10:24 EDT 2009 | olsa
Hello, this is my first question. More than 10 years my job was mobile phones repair, and for BGA repairing proces I used special template stencil, soldering paste and flux. Right now my job is notebook repair, and I'm interested about reballing of
Electronics Forum | Thu Apr 08 16:25:38 EDT 1999 | greg c
I am looking for a BGA rework/placement system and would like any experience that you have had. I am looking for a system that is reasonable for the placment, removing and re-balling thank you
Electronics Forum | Wed Oct 09 08:44:05 EDT 2002 | apg
Dear colleagues. I ask you to prompt me about necessity of drawing pastes through a stensil at the soldering micro BGA with step between leeds 1 mm and 0,8 mm or uses only a flux for this purpose. And what most suitable paste for the soldering of su
Electronics Forum | Fri Apr 09 12:46:10 EDT 1999 | Bob Barr
I have been using an Air-Vac DRS-22 for almost two years with very good results. Once a profile is developed it is very repeatable. The DRS-22 is no longer available, however. It has been replaced by the DRS-24. Unfortunately, the DRS-24 has a lo