Electronics Forum | Tue Aug 27 11:08:24 EDT 2002 | slthomas
We use an evaporator, so that we only have a sludge of flux residue and solder metal to dispose of via the hazmat handling service. We also route stencil washer waste water into it. We use a 30 gallon drum and have it hauled off maybe twice a year,
Electronics Forum | Fri Aug 16 11:03:22 EDT 2002 | Claude_Couture
I use Kyzen's Aquanox SSA cleaner in a heated parts cleaning tub to clean anything with flux condensate on it. When heated to 120F, the stuff melts away like ice under hot water. When the cleaning solution is loaded, I send it in an evaporator. The s
Electronics Forum | Thu Dec 26 16:51:47 EST 2002 | davef
First, an earlier poster suggested using DI water. We are NOT excited about DI water with a NC fluxer, unless DI water is the proper flux thinner. Second, as you inplied, the maintenance steps you take should vary according to the amount of time th
Electronics Forum | Tue Mar 16 14:23:44 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Mar 29 16:56:58 EST 1999 | Chrys Shea
| | Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there
Electronics Forum | Wed Sep 10 11:57:14 EDT 2003 | Mike Konrad
First, you must determine a few things: 1. What specific de-fluxing chemical are you going to use? Basic required determinations include the chemical�s pH, is it a VOC (if so, what is its VOC content), what concentration is the chemical used in (1
Electronics Forum | Mon Mar 15 09:38:30 EST 1999 | Chrys
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Mar 15 15:42:16 EST 1999 | George Steele
| | Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there
1 |