Electronics Forum: fried motor mydata (Page 1 of 13)

mydata 19 error

Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales

Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser

mydata 19 error

Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales

Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After

mydata 19 error

Electronics Forum | Tue Feb 11 14:42:49 EST 2014 | rdubya

Centering motor about to fail or has failed.

mydata 19 error

Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval

Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the

mydata 19 error

Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval

Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-

mydata 19 error

Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales

Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came

mydata 19 error

Electronics Forum | Thu Feb 20 13:56:18 EST 2014 | rgduval

Brendan, Unfortunately, I no longer have MYData equipment in my shop (I moved to a new company), so, I can't help with finding part numbers. I do know that you can buy the motor/counter units separately on the open market..and, I think you can buy

Mydata Centering motor problem

Electronics Forum | Mon Sep 21 03:52:17 EDT 2009 | darrenj

Found the problem. A small part had previously fallen off the nozzle, and ended up behind the left centering jaw preventing the jaw from opening up fully. Cheers Darren

Mydata Centering motor problem

Electronics Forum | Mon Sep 21 00:11:14 EDT 2009 | darrenj

We have a TP9 with a centering motor issue. (TPSYS Ver 2.5.3) The error message F-MOT-SETDYN C/3 Upper endpoint outside limits is shown during C-motor initiation. I've looked in the service program and also the parameters in TPSYS but can find no m

Loud humming noice from X-Wagon motor

Electronics Forum | Mon Oct 31 02:38:18 EDT 2011 | kenmar

Hi Phil, Thanks I will contact Mydata to see about a possible software upgrade.

  1 2 3 4 5 6 7 8 9 10 Next

fried motor mydata searches for Companies, Equipment, Machines, Suppliers & Information



World Source Equipment: Used equipment sale. Hundreds of items on sale.
Large PCB Dispensing System

ONLINE IPC Training & Certification
2022 Eptac IPC Certification Training Schedule

MSD Dry Cabinets


"Heller Korea"