Electronics Forum | Wed Dec 06 23:12:09 EST 2000 | Brad
Chris, Have you considered Fuji? The robustness of Fuji is proven. I have recently done floor space analysis and cost per placement/sqr foot studies. I have also performed ROI studies on these machines. The new CP7 machine from Fuji outperforms th
Electronics Forum | Mon May 10 17:21:03 EDT 2004 | smt..
I work with Fuji equipment For over 10yrs�. Cp3, cp4.cp6.cp7, ip1, ip2, ip3, qp341, qp242, qp351. Also, work with MYDATA, SAMSUN, and QUAD AMISTAR�. Fuji is the best in my opinion.
Electronics Forum | Mon May 10 17:21:08 EDT 2004 | smt..
I work with Fuji equipment For over 10yrs�. Cp3, cp4.cp6.cp7, ip1, ip2, ip3, qp341, qp242, qp351. Also, work with MYDATA, SAMSUN, and QUAD AMISTAR�. Fuji is the best in my opinion.
Electronics Forum | Fri Oct 08 17:07:19 EDT 2004 | Christopher
Hi > > For throughput seimens is the best and > footprint is smallest Fuji Machine ist the best on the world. I working on the Cp 6,CP 7, QP 3421 and Qp 351. Best regards Christopher
Electronics Forum | Tue May 11 01:18:35 EDT 2004 | fastek
Grant- Just so happens I was offered an almost new one today. Check them out and if a CP7 is indeed what you decide to get let me know and I'll likely be able to save you some money off of new. Rick fastek@comcast.net
Electronics Forum | Tue May 11 09:50:04 EDT 2004 | vickt
Grant,You should take a look around at all of the alternatives out there. There are many fine solutions from every SMT assembly vendor. Fuji is not the only game in town. You should not purchase on name brand alone. If you are considering the CP-7, I
Electronics Forum | Mon May 10 22:59:42 EDT 2004 | Grant Petty
Hi, Thanks for the info, and we are considering a CP7, as if we are going to spend the money, we might as well go all the way and get the speed. However I have seen some video of them operating, but am yet to see one. What is the placement accuracy
Electronics Forum | Tue Jul 20 04:16:02 EDT 2004 | Charles Huang
Wondering if there any CP7/F4G programmers out there that can help me out with this one. I'm assuming the setting for max and min nozzle in the "environment" section of the part data would allow me to use either the specified max OR min nozzle in th
1 |