Electronics Forum | Wed Nov 19 10:57:55 EST 2014 | jimmyboz
Oh yeah, You can flip to switch on the camera card, VM1710 and jog the PCB under the fiducial camera to visually inspect to placements. switch it back when you are done.
Electronics Forum | Wed Apr 17 02:13:22 EDT 2024 | acouto
Good morning, After the visit of an external technician due to the change of cables, when resetting the camera mark again when doing the inspection fails to check the calibration points of the conveyor. Is it possible that the technician has decalibr
Electronics Forum | Wed Apr 17 18:27:16 EDT 2024 | acouto
Yes, it is the same type, the problem only happened after the technician removed the mark camera and the light. The manual states that you should not move the mark camera light with your hands. So I think I may have miscalibrated the equipment in som
Electronics Forum | Wed Jun 14 16:27:13 EDT 2006 | vikkaraja
Talk to Fuji regarding this issue, there is retrofit kit for the mark read camera amp.( it's black color box on top of the machine from side one on your right hand side). And also check you software there might be upgrade available from fuji. I hope
Electronics Forum | Fri Nov 21 06:00:56 EST 2008 | ralphspm
Our Fuji IP2 m/c will not recognise fiducial marks. M/c lost all proper data and without any backup documentation on what data was originally inputted I have had to use educated guesswork. Is there info that needs to be in the proper data for the IP2
Electronics Forum | Sun Apr 25 21:01:57 EDT 2010 | m79d
Hi all our IP1(1993)is not reading the board fiducials, the light comes on at the fid camera and stay on and the machine just hangs. Need to press the emergency stop button to go any further and screen says 'mark not readable'. None of the bulbs h
| 1 |
