Electronics Forum | Mon Jan 10 03:12:27 EST 2005 | technitelec
are you looking for a used one or a new one, may i know what is the exact Fuji number is it fcp4-2 or fcp4-3 machine??? thank you serge
Electronics Forum | Thu Oct 02 01:59:06 EDT 2008 | edmaya33
Obviously nobody can help you Jack. 1. its the camera for parts recognition ( enhanced CMOS ). 2. positioning system upgraded from ball screw to linear motor/gantry. before CPH=16500 new CPH=18000 using H12S
Electronics Forum | Fri Oct 03 07:49:19 EDT 2008 | grantp
Hi, I just saw the new NXT machines at globaltronics in Singapore, and mostly they are faster. However what was interesting is Fuji shows a prototype of the new XPF machine, but it was called XPF-W which handles really large PCB's and uses the sam
Electronics Forum | Mon Mar 04 07:33:25 EST 2013 | cyber_wolf
*There are instructions that come with the amp on how to set it. *I have never had to replace a FRQ or FQ motor, or any motor on a Fuji for that matter.I highly doubt the motor is bad. *The meshing check sensor verifies that the clutch is engaging c
Electronics Forum | Thu Mar 04 22:37:58 EST 1999 | Larry Johnson
Does anyone out there have any information on this new "Fuji Motor Feeder" Price and how it compares to Hover-Davis. I should specify feeders for an Fuji IP-3. Any information would be great. Thanks Larry
Electronics Forum | Mon Mar 08 11:54:38 EST 1999 | Bob Schuster
| Does anyone out there have any information on this new "Fuji Motor Feeder" Price and how it compares to Hover-Davis. I should specify feeders for an Fuji IP-3. Any information would be great. Thanks Larry |
Electronics Forum | Thu Sep 15 16:02:20 EDT 2005 | jdengler
Over Current means the motor is drawling too much current. Check for a jam on that axis, bad wire, bad motor, bad servo amp (yes the amp can go bad and make it appear that the motor is drawling too much current). Jerry
Electronics Forum | Wed Oct 02 07:43:21 EDT 2013 | aj
could be a faulty motor? you can check the voltage at the connection to the motor when the IO is on.....or swap the motor.
Electronics Forum | Fri Jun 04 09:30:43 EDT 2004 | gregf912
Grant, The Fuji chipshooters are built with the same mindset as the hydraulic presses and huge motor lathes that were the CP ancestors. The first Fuji CP was a modified motor lathe. They are solid. I can move a Fuji across the country and not have t
Electronics Forum | Wed Oct 02 00:35:33 EDT 2013 | sonavc
thanks I tested the conveyor A or B , when it is on the motor turn and the green LED at the out put card is also light on. But when i turn on the X y table motor , the green LED is on , but the motor is not run. I will try to replace the I/O
.gif)
