Electronics Forum | Thu Jan 20 06:01:23 EST 2005 | mhe
Hi guys, we are facing a problem - d axis servo overflow in our fuji cp-4. Can anyone please suggest some remedy? thanks deepak
Electronics Forum | Fri Jul 19 12:58:46 EDT 2013 | markhoch
The wonders of Google... Hope this helps. http://www.winsmt.com/down/001.pdf
Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
Electronics Forum | Wed Oct 27 10:22:15 EDT 1999 | a.blair
Fuji is usually the cheapest you will find. I think around $750 for them to repair it. the last time I checked they have an exclusive patent on their PCB backplane design so there would not be any real way to bench test it. they also have rights to t
Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
.gif)
