Electronics Forum | Tue Oct 11 07:54:26 EDT 2005 | Mark
254 (odd parts) ........ go into the Flexa program and go over the vision number and click on it and than hit F1 for a list of numbers.
Electronics Forum | Fri Oct 21 03:56:47 EDT 2005 | aj
I agree, Vision 254 should do the job. Input total x and y dimensions of the component.
Electronics Forum | Mon Oct 10 22:29:04 EDT 2005 | matjen
We are trying to place a connector with a IP2 but every vision # we have tried will not place the connector, If anyone has any flexa experience or knows a vision # that we can enter in that will place a odd shaped connector please let us know, Th
Electronics Forum | Thu Oct 13 14:14:10 EDT 2005 | rcanten
It depends on the type of connector but if you have a connector that has projections on the ends that look similar to leads in the lighting you will be hard pressed to get this to place with anything other than a vision number 6 on a IP2 and then the
Electronics Forum | Mon Nov 26 14:22:42 EST 2007 | scotceltic
If it is anything like my Flexa then you would have to purchase the IP2 module license in order to communicate with the machine from flexa. I have had to purchase separate licenses for my different pieces of equipment. CP6, NXT, QP3, CP7
Electronics Forum | Fri Jun 04 13:23:54 EDT 2010 | mmjm_1099
For the machines that are similar I would start by making sure the model name and machine name are different. The machine type can be the same but you need to add a different sufix at the end or something. See if this helps and should be able to do s
Electronics Forum | Fri Oct 17 20:26:21 EDT 2008 | diesel_1t
If is IP-1, is using SMD2 vision instead of SMD3 (CPIV-IP3, CP6,7, etc) if so, you must use Vision Number instead of Vision type... if you're using fuji flexa just press F1 on vision number and you will se most common vision numbers depending on shap
Electronics Forum | Wed May 26 05:58:50 EDT 2010 | chrislyttle
Hi, first time posting on here. We've recently acquired additional Fuji machines to add to our line and have moved premises to a new factory. I've been trying to set up a new factory line in Line Editor to use two of our existing machines (Fuji GSP
1 |