Electronics Forum | Fri Oct 02 17:06:02 EDT 2020 | dilogic
Is there somebody experienced in GSM Flexjet calibration procedures? I have some issues that I can't resolve and help is very appreciated... - Deni
Electronics Forum | Mon Jan 04 12:29:26 EST 2021 | ilavu
What error you are getting and at what stage? Why are you calibrating?
Electronics Forum | Thu Jan 07 19:38:12 EST 2021 | ttheis
Hi Deni, I just bought a machine with FJ9 heads- I have never had a flexjet, only regular flex heads. Are there any pointers you can share? What ended up being your problem? When you do a calibration, do you do the CPE also? I have been fortunate
Electronics Forum | Wed Jan 06 02:37:46 EST 2021 | ttheis
Don't know if this is relevant but I just came across this bulletin in the UIC docs: Document # TECH-0155 Software level:All Machine block:All Machine type(s):GSM1 Platform,GSM2 Platform,GSMx Platform,GSMxs Platform Target Users:Level 2 Topic:Part
Electronics Forum | Thu Jan 07 19:22:55 EST 2021 | dilogic
Thanks, I have read (almost) everything I could find on UIC's site. The problem I had was that I never before tried to perform FJ calibration, so I did not know how it normally works. Anyway, I figured out what I did wrong and managed to calibrate t
Electronics Forum | Tue Jul 19 00:34:36 EDT 2022 | ttheis
We found that the "Z offset" on the head was altered relative to the other machine and restoring defaults made both machines display the same settings. Once defaults were restored for the second machine, it began picking up the card from the tray and
Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Fri Feb 19 15:23:31 EST 2016 | ttheis
RESOLVED I adjusted the "Minimum Board Width" in the Board Handling Configuration to resolve this issue. I set the lane width to a larger value which did not hit the front limit and measured the difference between the actual lane width and the set l
