Electronics Forum | Wed Feb 18 22:18:26 EST 2009 | davef
"acrylic adhesive" "high temperature" tape
Electronics Forum | Tue Feb 17 22:52:11 EST 2009 | davef
Hey Roland How come capton beginning with a 'K' gives an error message?
Electronics Forum | Wed Feb 18 12:21:42 EST 2009 | glynnhamer
HI again Dave, I was wondering what kind of problems you were experiencing with the silicone tape that led you believe that it wasn't the correct tape and question the manufacturer? Were there more failures and solder issues ? Thanks
Electronics Forum | Wed Feb 18 20:15:30 EST 2009 | davef
Glynn We allow no silicone in our shop, because it ruins solderability. For more look here: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=47025
Electronics Forum | Wed Feb 18 07:09:14 EST 2009 | glynnhamer
Thanks Dave, I have the correct part number from 3m, but like I said they want to only sell it buy the case, and it's expensive. I was hoping someone might know of a distrubutor that might sell in lesser quanities, or a different brand. It sounds lik
Electronics Forum | Tue Feb 17 22:49:14 EST 2009 | davef
Try: acrylic adhesive Klapton tape [google for a source] It too is more expensive than the silicone adhesive tape. So, your buyer will keep trying to sneak the cheapo stuff in on you. We had to write a procurement specification and they still wont q
Electronics Forum | Tue Feb 17 15:24:17 EST 2009 | glynnhamer
I know this is going to sound rather sad, but we have been using a Capton tape for years that contains silicone to mask large components as they go over the wave, as well as large plated holes on the pcb. It was handed down for years as accepted prac
Electronics Forum | vsuresh |
Sat Mar 23 05:36:36 EDT 2024
Electronics Forum | Thu Mar 28 19:36:21 EDT 2024 | linux
ensure the nozzle is inserting fulling into the nozzle holder. ensure shaft is lubricated, clean between the magnetics on the shaft. complete nozzle height calibration
Electronics Forum | Fri Mar 23 07:17:50 EDT 2007 | Phil J
Stefan The Z hight required for a MELF will depend on the design of nozzle used on your machine. If it has a "V" tip you should measure the hight of the component on a nozzle then subtract the nozzle hight.
