Industry News | 2021-11-04 21:34:47.0
Hollow shaft encoder is also known as hollow encoder. When installing this type of encoders, it is necessary to avoid rigid connection with the encoder. Please refer to the instructions for the size of the installation shaft. When installing, the encoder should be gently pushed into the quilted shaft. It is strictly forbidden to knock with a hammer, in order to avoid damaging the bearing and the encoder as whole. After a hollow encoder has been used for a long time, you should check whether the screws fixing the encoder are loose.
Industry News | 2019-12-16 22:31:09.0
Vacuum reflow solder is refers to the vacuum eutectic oven, vacuum in vacuum environment for high quality welding products, in the welding process of zhongtong into reducing system (N2, formic acid, N2H2, H2), to protect the product and the solder is not oxidized, at the same time the product and solder oxide on the surface of the reaction, make weld surface quality improvement, reduced the rate of welding hollow.
Industry News | 2021-11-02 21:27:05.0
The wiring and installation of rotary encoders should be conducted in strict accordance with the instructions of each product. While for general encoder installation guidelines, you should pay attention to the following aspects during your encoder mounting work.
Industry News | 2017-04-22 11:38:03.0
Specialty Coating Systems (SCS) is pleased to announce that it will exhibit at the 2017 IMAPS Micro/Nano-Electronics Packaging and Assembly (MiNaPAD) Forum, scheduled to take place May 17-18, 2017, in Grenoble, France, at the WTC congress center. The company will exhibit its industry-leading Parylene conformal coatings and SCS Vice President of Technology Rakesh Kumar, Ph.D. will present, “Parylene Nanostructures and Coatings for Electronics Applications.”
Industry News | 2019-12-16 22:38:22.0
With a history of more than 28 years since 1990, icict has been committed to building the most influential and innovative ICT platform, providing comprehensive services, communication and cooperation opportunities, including policy interpretation, technology research and development, market application and financial investment, for the ICT industry chain.
Industry News | 2014-04-08 11:43:03.0
Isola Group has launched a technology-licensing program to mitigate conductive anodic filamentation (CAF) problems in the fabrication of PCBs. This proprietary manufacturing technology, which is offered by ISOLA USA Corp. "Isola USA", reduces the number of voids in resin-impregnated dielectrics, which is a major source of CAF failures.
Industry News | 2019-12-16 22:47:11.0
The difference between gas phase reflow welding and hot air reflow welding is that gas phase reflow welding USES vapor phase liquid to heat the key.
Industry News | 2019-11-05 22:19:03.0
> News-Blog > Guideline for wire bonding Guideline for wire bonding Tuesday,Jun 12,2018 There are two wire bonding processes that are used, Thermosonic (T/S) Gold Ball Wire Bonding and Ultrasonic (U/S) Aluminum Wedge Wire Bonding. Approximately 90% of all IC Assembly in Semiconductor Packages is manufactured using Gold Ball Bonding process, while Aluminum Wedge Bonding is used to produce about 10% of other Wire Bonding requirements on Printed Circuit Boards (PCB), Printed Circuit Flex (PCF) and other Packages.
Industry News | 2020-11-24 00:27:11.0
Research on non-precious metal catalysts. Research progress of non-precious metal catalysts for proton exchange membrane fuel cells
1 |