Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Fri Oct 03 11:26:31 EDT 2003 | radney
We have been through several stages of this journey. We had no verification initially, migrated to two person verification (with reel initialing) and finally to electronic verification. Each of these steps has given us a dramatic improvement in our
Electronics Forum | Fri Feb 23 09:29:59 EST 2007 | chrisgriffin
I did restore the .ma files, and yes, the computer does communicate with the gantries for zeroing. But the machine is still hung on "initializing machine". It never asks me to push the start button. It is like it is trying to collect necessary dat
Electronics Forum | Tue Dec 21 09:22:52 EST 2010 | cwhite30
I have a camalot 1818 dispensing system, but it recently stopped booting up. It gets to the 197 vision initialization screen and then freezes with the message "bad command or file name could not communicate with vp" Does anyone know how to fix this?
Electronics Forum | Sun Jan 02 11:41:54 EST 2011 | ev
First we get a "transducers out of sync" error which can be corrected when we go to the "reinitialize hardware" option in the Utilities menu. However, when it fails to initialize the error is "Xfan not working".
Electronics Forum | Mon Jan 03 09:36:02 EST 2011 | markhoch
There is a fan on the upper rear of the machine that has to be running for the machine to initialize. i suggest lifting open the top and check the operation of the cooling fans.
Electronics Forum | Tue Jan 04 15:11:57 EST 2011 | ev
The Xmotor tests just confirms that the hardware did not initialize.....unless I am looking at the wrong menu. I have external fans on the booster board and the X motor on the back of the machine as well as one blowing directly into the computer box
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
