Electronics Forum | Thu Aug 23 11:20:51 EDT 2018 | gregcr
Hi All, I am looking for a tech able to provide final install and training on a MySelective Soltec 6748 machine in South East Massachusetts. Recommendations would be appreciated. thanks
Electronics Forum | Wed Aug 04 18:12:27 EDT 2021 | tomdegas
I am trying to install an A12 tool on my MY15 and I get the following error: "F-TLMN-9: Failed preliminary fetch during installation" I looked it up and it says Operator error and that the tool is missing. The tool is in the tray and the MY15 picks
Electronics Forum | Wed Aug 04 23:32:05 EDT 2021 | tey422
Seem like sensor failed to detect the tool is fetched. You might want to try to clean the inside barrel of the fetch tool. Use the foam swab, to clean it. If it's a spring loaded tool that you trying to install, you have to make sure the top of the
Electronics Forum | Thu Aug 05 17:32:31 EDT 2021 | cyber_wolf
Including non-spring tools ? Additionally I assume you know how to use the tool install utility and have looked for things like cracks in the big ribbon cables on the X ? Tools are not dry and have white grease on them etc ? There is a show force
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Thu Aug 05 15:06:02 EDT 2021 | tey422
The last time I work on the Mydata machine was like over 15years ago. Sorry, I couldn't provide much more help than what I could remember so far.
Electronics Forum | Thu Aug 05 17:19:26 EDT 2021 | cyber_wolf
Will it pick up an A13 or A14 ?
Electronics Forum | Thu Aug 05 17:23:22 EDT 2021 | tomdegas
I just tried and I am getting the same error for all the tools.
Electronics Forum | Fri Aug 06 14:06:04 EDT 2021 | cyber_wolf
Hit the space bar when the tpsys menu comes up when booting . There is something in there that says show transducers. I think that's where you will find z-force sensor
Electronics Forum | Thu Aug 05 14:55:32 EDT 2021 | tomdegas
Tom I did as you instructed but same results so I actually changed the harness that has the two sensors (LED and RECEIVER) on the Z motor with a new spare I had hoping that was the problem. Alas that didn't solve it either. Any other suggestions?