Electronics Forum | Wed Jul 04 02:04:22 EDT 2001 | Mike
Hi Dave, Thank you for your information. How about the glue print on PCB and not mount component, what is the idae to inspection this glue is suitable for mounting component. For example insufficient glue excessive glue. Because we found the problem
Electronics Forum | Thu Mar 22 21:59:55 EST 2001 | dblsixes
ah ... but we had insufficient heel fillets in the old design toom when we had more pad area ... just not as bad
Electronics Forum | Thu May 22 09:59:54 EDT 2003 | russ
You also would want to talk with your flux supplier. They are usually knowledgeable in the proper application of and heating of their fluxes. Usually, insufficient solder in a wave process is related to insufficient preheat,dwell time, and flux app
Electronics Forum | Thu Dec 08 19:14:38 EST 2005 | khp_armin
We are encountering insufficient solder paste. Our stencil thickness is 0.13 mm and our printing pressure is 0.08 MPa our solder paste is Tamura TLF-204-19A. Please advice how to solve this problem.
Electronics Forum | Fri Feb 24 02:04:50 EST 2017 | soldertraining
Selective Soldering Frames can pull large amounts of heat from the solder wave at the point of contact, effectively lowering the temperature of the solder at the solder joint. You should confirm the temperature of the solder joints by running a therm
Electronics Forum | Fri Mar 23 18:55:30 EST 2001 | davef
Consider posting actual measurements of your pads, component leads, and apertures.
Electronics Forum | Thu Nov 07 15:55:30 EST 2002 | Debi Musante
The XRAY looked okay with minimum voids throughout. Customer reports insufficient contact causing intermitten failures.
Electronics Forum | Fri Dec 01 07:46:41 EST 2006 | davef
Bridging Causes: * Insufficient flux * Excessive pre-heat * High conveyor speed * Solder contamination
Electronics Forum | Tue May 22 08:39:23 EDT 2012 | davef
Bridging Causes: Insufficient flux, excessive pre-heat, high conveyor speed, solder contamination [AIM Solder]
Electronics Forum | Thu Nov 07 12:35:38 EST 2002 | slthomas
Sounds like you're talking about the "heel" of the lead not being soldered, in other words, no heel fillet, which IS necessary. That problem, for us, was attributed primarily to poor layout (insufficient length of pad extension to provide room for