Electronics Forum: jot and control and conveyor (Page 1 of 1)

Conveyors and bar code

Electronics Forum | Fri Aug 25 08:12:16 EDT 2006 | davef

Leading conveyor manufacturers are ATI, Conveyor Technology, Crown Simplimatic, Dynapace, Flextek, Fuji, Jot, Kanetic, Panasonic, and Process Control.

Conveyors and bar code

Electronics Forum | Wed Aug 23 14:59:32 EDT 2006 | bill

I�ve been lurking on the forum for a while so I will take a stab at this, mainly because there is no answer I take it that you have a variety of boards being produced at the same time and are in fixtures so the conveyors don�t need to be adjusted, a

SPC and Wave

Electronics Forum | Thu Jul 14 11:52:16 EDT 2005 | davef

Sure you can use SPC charting on the wave setup parameters to warn of impending problems. Examples of useful points of analysis are: * Dwell * Temperature * Pot analysis Certainly there's a range of other process controls that could be monitored.

Printer and Reflow Oven Recommendations

Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag

I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque

wave soldering and solder bridge

Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc

5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht

Via holes and Wave Solder

Electronics Forum | Mon Mar 13 14:26:45 EST 2006 | Wave Master Larry

Well, im not sure what plane you guys are on, but I can back up my what im talking about. Ya see I wnet to Soltec traingin back in 1995 for our new wave. I got a diploma proofing that I know what i'm talking about. no one else in my company has on

No solder and solder bridge after Wave solder machine

Electronics Forum | Thu Nov 17 21:46:48 EST 2005 | C. Kolokoy

With DIP type components, a sub-par fluxing method (foaming a no-clean), and a chip wave where one is not needed are formulas for bridging and insufficient wetting. If you have SMD's on the wave solder side of the board greater than 0603, and no SOT

Step by step guide in evaluation of Solder Bar and Flux

Electronics Forum | Mon Dec 11 20:44:37 EST 2006 | davef

Title : LEAD-FREE WAVE SOLDER FLUX EVALUATION Author : Michael Havener Author Company : Benchmark Electronics, Inc Date : 09/25/2005 Conference : SMTA International Abstract : The European Union�s deadline to ban lead in electronic pr

  1  

jot and control and conveyor searches for Companies, Equipment, Machines, Suppliers & Information