Electronics Forum | Fri Sep 24 12:02:57 EDT 2004 | Frank
Yes, I can see your problem, the nozzle makes only good contact in the center and so the ends don't make good contact. The ends tend to curl up during reflow. There were two suggestions to solve this. 1) Let the operator push down the labels befor
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Tue Apr 02 17:15:58 EDT 2013 | dontfeedphils
This is where I purchase nozzles for our Jukis. You don't have to purchase the entire nozzle assembly, just the tip and slider... http://www.nozzlesupply.com/juki.htm I don't have any affiliation with this company, just a happy customer.
Electronics Forum | Tue Apr 02 13:43:54 EDT 2013 | ericrr
On one of the products uses a QFP (Quad Flat Package)which is not going on straight, maybe 20 pins per 4 sides. sometimes I have to tweak the alignment before the board goes in the oven, this practice can be a bit of a worry if you over tweak it - pa
Electronics Forum | Wed Jul 22 05:54:41 EDT 2015 | langkeauto2015
Hi, Tsvetan, sorry for your bad experience for Chinese brand PNP machine. For your doubt, pls refer to my comment:) Our pnp machine is special for led tube, led panel, led strip, RGB strip, and led display screen PCB, and real working speed feedbacke