Electronics Forum | Tue May 05 15:12:29 EDT 2020 | electronicsprecis1
I have a Juki 740 that was working great until one day a motor cable broke and after this messege the emergency stop button has been pressed..." error popped up when I turned the machine on. I know the emergency stop works all the way. Does anyone ha
Electronics Forum | Mon Mar 19 09:24:46 EDT 2018 | grek
Hello, try to find Operation options on your machines And try to find something like: Treat the same components as alternatives feeders. I know only 2070/2080 but it could be similar. Not sure if this is what you need but you can try
Electronics Forum | Tue May 17 01:32:34 EDT 2022 | sarason
Another method would be to do a screen dump on a Juki 2070,2080 machine, but that gets you back to the chicken and egg scenario. My program PCBSynergy doesn't reverse out the board file from a machine file while Ealead does . Also the programs EPU, F
Electronics Forum | Mon Aug 05 18:17:31 EDT 2013 | starlogixs
No the actual Juki software for the machine. Need to calibrate the machine after a motor replacement. Regards Mark
Electronics Forum | Sun Aug 04 19:42:50 EDT 2013 | starlogixs
Thanks for the reply Sarason. The software looks interesting, as we are a small manufacturer. However I do need the original Juki software for a calibration file. The X axis motor has been replaced but the calibration file is missing to teach and ca
Electronics Forum | Sat Mar 04 11:07:21 EST 2006 | charls
hi pavel, If you are getting vibrate during fast mode, encoder or motor cable might be faulty. yes i faced the same problem in Juki KE2010 m/c. Try by replacing encoder & motor cable from Motor to driver unit. All the best
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Wed Mar 28 12:24:57 EDT 2018 | reckless
https://www.ebay.com/itm/Juki-KE-760-SMT-PICK-AND-PLACE-MACHINE/282894334640?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 Not sure if a Juki 760 is worth $7300 shipped with feeders, MTC, etc. I saw a video of it running and it looked
Electronics Forum | Fri Sep 08 11:06:11 EDT 2006 | fabio
the video and the servo motors don't start... i need a wiring diagram to make the measures... please help!!
