Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Fri Aug 28 19:54:05 EDT 2020 | emeto
From what you explain: 1. check all movements X,Y and Z are moving free while machine is off. 2. Resit all driver cards. 3. Check interface cables or boards. Not sure if Juki is using CAN or other interface standard, but random motor errors might be
Electronics Forum | Sun Sep 01 22:02:58 EDT 2019 | sarason
Have you got a circuit diagram for your driver board? If not measure your driver into a resistive load and look for differences in current flow voltage drops under load dried out caps. Dead current measuring circuits etc. If you see an IC, look it up
Electronics Forum | Mon Sep 03 07:17:43 EDT 2018 | oriolsancheza
Hello everybody, For a long time the Juki has been not used, but was working fine before that. Since 4 or 5 month ago, it brings some problems when initializing with T and Z Axes. Till now, just powering it off and on for a few times worked, but no
Electronics Forum | Mon Aug 01 10:31:34 EDT 2022 | spoiltforchoice
I'm not familiar with the machine, but isn't a KE760L an old slow "single head, single gantry" two spindle machine? Any speedup from simultaneous picking would not necessarily be that much of an improvement. Setup as you described is the way I would
Electronics Forum | Wed Sep 05 06:34:08 EDT 2018 | oriolsancheza
Hi Rob, Thanks for your fast response. In fact, after a better look to driver boards, it has leaking SMD Electrolityc caps. Unfortunately after replacing them in 3 units, one of them gives 90% of times, ALARM4 led ON. Looks like a comunication pro
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
