Electronics Forum | Wed Jul 12 19:13:18 EDT 2006 | russ
i have heard of washable no-cleans for about 6-8 years now. I would think that if SIR values are acceptable for end use then I would run with it. Russ
Electronics Forum | Fri Sep 21 01:31:13 EDT 2001 | Stoney Tsai
Guys, If there are any specifications or ciriterions for solder paste deposition thickness and volume evaluation. For example, QFP (0.5 mm pitch), 6~8 mils, 3000 mil^3 PLCC: 8~10 mils, ... . . Thanks in advance. Best Regards,
Electronics Forum | Sat Oct 17 23:54:15 EDT 1998 | Kallol Chakraborty
the size of panel > is the free real-state) or greater, would help in selective stiffening of the panel itself for multiple placement for multiple assemblies hence achieving cost reduction. Hope it helps. If you need any info. for our company for t
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
| 1 |
.gif)
