Electronics Forum | Wed Feb 20 08:17:32 EST 2008 | ck_the_flip
Steve, KIC does. The new KIC2000 has built in dwell time sensors. You can buy KIC's wavesurfer option (like MOLE's waverider), or you can engineer a custom pallet for 1/3 the price. I made a custom pallet and took advantage of the KIC's automatic
Electronics Forum | Mon Feb 18 15:44:49 EST 2008 | ck_the_flip
Yup! All the major players out there - KIC, Datapaq, and ECD - are all capable of profiling both reflow and wave solder. check them out. www.kicthermal.com www.ecd.com www.datapaq.com
Electronics Forum | Tue Feb 19 07:44:41 EST 2008 | tonyamenson
So just to clarify.... If i bought a KIC 2000 I could run that one unit over both my waves and through both my ovens (leaded and lead-free)? Or would I need additional equipment to use it on the wave?
Electronics Forum | Tue Feb 19 09:41:26 EST 2008 | slthomas
ECD sells the MOLE, and they sell both the Oven Rider and the Wave Rider to accompany it. The thing is, you can profile both an oven and a wave machine without either if you're willing to just solder your thermocouples to a board. The nice thing ab
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Fri Dec 15 18:36:46 EST 2006 | Grant
Hi, I have noticed we are getting residue on our wave pcb's and it's worse with lead free, since we changed to the flux we are using. We are currently using Avantec VOC Free flux model Ecofree 303. It looks like it's made in Malaysia. Does anyone h
Electronics Forum | Mon Jul 28 13:21:50 EDT 2008 | realchunks
Do you have a Slim-Kic? You can run a profile and then do predictions from there. Very useful tool.
Electronics Forum | Fri Aug 01 21:10:35 EDT 2008 | leo_dektec
You can keep only the 5th zone as the reflow zone. And lower the first two zones to keep a good ramping rate. Meanwhile,please note the ting temperature in software or control panel is not the exact temperature in your PCB, you'd better get a KIC or
Electronics Forum | Mon Dec 17 13:58:54 EST 2007 | ck_the_flip
I made my own wave measuring device using KIC2000 system. KIC2000 has automatic wave detection, so now I have a profiler for both reflow ovens and wave solder. The delmat carrier only cost $500. A guy, Samir, from this forum gave me the idea, actu
