Electronics Forum | Thu Feb 14 02:36:55 EST 2019 | dimamalin
Hello everybody,if someone have KY-3030 programming manual Instruction pdf ,please send me to my mail dima_ma@usr.co.il Thank in advance Dima
Electronics Forum | Thu Feb 14 03:49:56 EST 2019 | dimamalin
Thank you , it going to be very useful
Electronics Forum | Tue May 11 12:33:21 EDT 2021 | lpbro
KohYoung>KY-3030>WinMCS.exe. We have WinMCS load on start up, there is an icon in the windows taskbar when it's running as well.
Electronics Forum | Thu Feb 14 03:38:51 EST 2019 | bane016
I have and will send..but i'm not at job right now...tomorow will send.. KY is easy to programing if you have gerber data...i can write here steps how to programing
Electronics Forum | Tue Oct 22 14:43:20 EDT 2019 | kathylci
Looking for someone to speak with regarding a Koh Young 3030VAL. Want to find out some information on the ease of programming for this unit. Any help is greatly appreciated! Thanks- Kathy
Electronics Forum | Sat Nov 09 14:15:18 EST 2019 | linux
Perhaps I can help you out, have experience with kohyoung Spi and AOI
Electronics Forum | Thu Mar 24 23:41:40 EDT 2022 | glasscake
Another oddity, when I unplug the PCI1/2 cables and cycle power I still get the same error.
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
1 |