Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Mon Jan 30 17:42:50 EST 2017 | jrr3434
A few of the LEDs on the cameras of my stencil printer are really dim. I want to replace them and not have to buy a whole new light ring board. Does anyone know what kind of LED they are? Any info would be appreciated. Thanks.
Electronics Forum | Wed Jun 13 01:01:10 EDT 2012 | isd_jwendell
I clean all fids with a fiberglass brush pencil so that I know there will be no rejects (it doesn't take too long). The problem is the machine lighting. My Essemtec machine uses a light ring (red LEDs) around the cam. Here's one of many documents th
Electronics Forum | Fri Nov 06 15:42:58 EST 2015 | sdmideas
I am having a darn hard time getting my upward vision to successfully inspect a ssop14 package. I have created a part profile as defined by the manual as I understand. I believe the profile is ok based on comparison to like parts referenced in the q
Electronics Forum | Wed Sep 04 12:50:40 EDT 2019 | smrsteve
Thanks for that Steve - I'll try anything at the moment, but that sounds like a reasonable suggestion. I've already replaced a few cables that looked dodgy, and the LEDs on the LED rings, but I've not done a ribbon cable on the head yet. I shall hav
Electronics Forum | Tue Oct 09 10:29:47 EDT 2018 | dfl
Thanks Bob. Using a flashlight helps a lot, indeed. Is "re-adjust the angle" just a bend on the LEDs heads (by hand)? I will try. To replace de LEDs, can I use white ones? I believe with the reds I get less light than whites, but maybe the camera ne
Electronics Forum | Sun Aug 28 23:53:58 EDT 2016 | aemery
I don't think there is a camera off message in the software, but I might be wrong. So I am making a bit of an assumption here that you didn't have a displayed image and your error was a fiducial not found error. I am also wondering if you decided to
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Fri Nov 06 20:43:58 EST 2020 | jmelson
Does anyone have schematics for the PC board inside a Quad IQ feeder? I have one that worked a few days ago, but now gives me blinking lights and doesn't move. Or, do you know what to do when it won't move? I have checked the contacts and the feeder