Electronics Forum | Thu Sep 26 13:55:54 EDT 2019 | ttheis
One of our GSM1 machines occasionally stops running in the middle of a program and I haven't been able to figure out what is causing it. When the issue occurs, the "BM" (bus master) light on the SYS68K card drops out (turns off, no activity) the boa
Electronics Forum | Wed Jan 25 22:42:23 EST 2006 | davef
We are considering replacing the lighting used in our manufacturing area. This is the overhead lighting, not task lighting for workstations. Currently, we have long strips of fluorscent light pairs that are spaced about 20 feet apart. The ceiling
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
Electronics Forum | Tue Oct 21 06:19:50 EDT 2014 | navworx
Hello, We have an MPM 2000 HiE printer. when opening the lid, the light does not come on. It looks like a typical kitchen fluorescent light fixture. Replaced the bulb, but still does not light. Does the fixture have the starter inside?
Electronics Forum | Thu Oct 23 00:43:30 EDT 2008 | stanyserrao
Light Units are replaced with new if the problem of lights then it will not vision process the nozzle center measrement and resolution Jigs too.. Jig is meauring in trace mode and identifiying all leads which are fine fitch. But a 1206 resistor is
Electronics Forum | Fri Jan 25 10:15:56 EST 2019 | babe7362000
Does anyone know what Led is used on the Yestech B2 light boards. I need to replace them and can not find a board, so I need to replace the LEDS. Or is it something else causing the leds to not go any brighter?
Electronics Forum | Mon Feb 01 19:45:44 EST 2021 | rodrigo
Hi all, One of the lights in head 1 (IP3) just went bad. A new one is about $150 (model 110b). Are there any replacements? LED maybe? Thanks
Electronics Forum | Mon Sep 20 00:51:03 EDT 2010 | jeffr
This particular Yamaha Head I/O Board is a common failure. Yamaha supply an updated version which is less likely to fail. The cause of the problem that you see is due to the connectors on the flexing and damaging the inner layers of the board. The on
Electronics Forum | Thu Aug 30 19:39:15 EDT 2007 | davef
Rob If your supplier replaces your carbon bed when the ion beds require replacement [when you call after the light goes red], it will not hurt anything, except increase your costs.
Electronics Forum | Wed Nov 12 16:04:11 EST 2008 | charliedci
I have about 8 pair of the 590 in use in thru hole production. Had to replace 1 set of blades because of overpressure (50psimax) and a valve over past year. They work well for light to medium work. The replacement blades were around $20.00.