Electronics Forum | Thu Sep 01 11:45:48 EDT 2011 | emeto
You can bet it was a conspiracy. Customers don't usually chew the PC boards inside their TVs,coffee machines or other electronic equipment. And if Lead is so dangerous why do we still run it and we still have to talk about problems about Lead. An
Electronics Forum | Tue Aug 05 13:04:35 EDT 2003 | caldon
Our machines are Single phase 220v. The big honkin' hubble plug goes right in the back of the UPS for the whole machine...no seperate lines for the PC's. Also the UPS is dedicated just to the machine even though it has a 120v Recepticles. Cal
Electronics Forum | Mon Mar 30 11:02:37 EDT 2020 | SMTA-Eric
As we navigate through the CORVID-19 pandemic, many essential manufacturing facilities are still on line and operating. Some at reduced or modified schedules in following the guidelines to help reduce the spread of this virus. My question is in rega
Electronics Forum | Sat Sep 23 21:52:51 EDT 2017 | jlawson
In most cases PnP files are all that is needed for SMT program generation. BUT, it depends on origin reference of this data as exported to PnP and could be off in X,Y and rotation of image pending when PnP Data is exported. Also Rotation of parts
Electronics Forum | Thu Apr 18 04:32:39 EDT 2019 | awelektronik
Hello, we have on Windows XP the Siplace Pro 5 as Desk and Linecontroller. We would like to upgrade the OS to Windows 7 but the Software wont work after. We need the installation files. Does anyone can shere the Install files with us? We have only
Electronics Forum | Wed Mar 18 16:15:49 EDT 2020 | emeto
Katrina, if the machine will zero on its own, there is nothing wrong with machine itself. You can now look into network cards in both line computer and line PC.
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Thu Mar 05 17:28:37 EST 2020 | sportsradar
I am desperate. I have an 80S15 with a single line controller that we program with and control our 80S15 machine. Everything has been working great until last month. We have not done any changes, and no new programs or jobs. We went to start the PC
Electronics Forum | Mon Mar 09 16:22:05 EDT 2020 | sportsradar
Hello Kristof, We use 1 PC which does line control and programming. We always boot the PC up first, then when it is fully booted, then we turn the machine on, we let it zero set, then we send the job over (this is how we do it when everything works)
Electronics Forum | Wed Mar 18 18:22:32 EDT 2020 | sportsradar
I have replaced both cards on the machine and the card in the PC. I have also replaced the cable. I can see where the machine is sending the request for data (by the screen shoots above). And I can see the PC is seeing something from the machine by
