Electronics Forum | Wed Jul 08 16:01:23 EDT 2015 | goodting
Hi Gentlemen/ladies: Can someone tell me where I can buy a GSM Advantis feeder loading station(for used one)? Appreciated your information. GTing
Electronics Forum | Thu Jul 09 16:34:46 EDT 2015 | davef
Look at the blue colored "New SMT Equipment" and "Used SMT Equipment" nav tabs on the left side of this screen.
Electronics Forum | Fri Jul 10 13:46:18 EDT 2015 | goodting
That is the good site to looking for... Thx
Electronics Forum | Tue Jul 14 13:13:35 EDT 2015 | goodting
Not found, any recommendation?
Electronics Forum | Wed Jul 15 11:42:24 EDT 2015 | davef
Here’s what you should try: * Go to the “Used SMT Equipment” nav tab [left margin, upper part of this page] * Click “Add Item” button [weird orangy, peachy color button, right side, near top, above thick blue line] * Complete form, making sure that y
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Tue Jun 25 10:36:10 EDT 2002 | Vincent Balboni
Do you have a fixed number of components that you write off each time a feeder is loaded.
Electronics Forum | Tue Jun 25 11:26:11 EDT 2002 | pdt203
Sometimes when a customer has sent parts on reel without any leader, we will take out the first 5-8 parts and then tie off the cover tape with some leftover tape from the last run. We keep those parts we removed and then place them back in the feede