Electronics Forum | Mon Jul 13 06:30:59 EDT 2009 | hcarrasco
1.- Check your vacuum a.- Check filters b.- Check air flow (the vacuum is generated by a Ventury using air flow, not air pressure) c.- Vaccum vias (Possible linth inside the vacuum lines) 2.- Check the nozzle condition (Probably broken o
Electronics Forum | Tue Sep 05 17:17:07 EDT 2023 | compit
1. What machine? 2. Check the ones that have fallen down for shape defects (badly adhere to the nozzle).
Electronics Forum | Fri Mar 21 08:39:38 EDT 2008 | lococost
If you are saying you're going through 1kg/h while only producing 300 pcbs a week and the rest of the time the machine is standing still, then 1.there is something seriously wrong with your machine or 2. check if an operator is suddenly covered in sh
Electronics Forum | Mon May 02 23:26:12 EDT 2016 | ttheis
Is this a dual-beam GSM2? Check to make sure the machine configuration is correct for the machine, otherwise I would look at encoders for the axis and electrical connections.
Electronics Forum | Fri Dec 05 13:57:37 EST 2014 | emeto
Hi, Do you observe any part warping in the corners? Do you X-ray 3D? I really doubt that all joints are fine and the part wouldn't work, but if so, your problem should be part related.If you have a temperature controlled facility I wouldn't even thi
Electronics Forum | Sun Jul 05 23:30:01 EDT 2009 | jeffr
A feedback error means that a particular axis did not respond by moving in a normal manner. Check the following:- 1/.. Mechanical binding. (Servo Off, then check axis moves without binding). 2/.. Check encoder plugs of that axis. Note that Philips/Ya
Electronics Forum | Thu Sep 16 18:25:22 EDT 2010 | slwolbert
Thanks for the response Travis. I'd think the table would inch or move if it were stuck inching keys. The table would eventually trigger one of the overtravel sensors on this ancient machine. Much Appreciated, Steve
Electronics Forum | Wed Nov 09 17:22:06 EST 2022 | emeto
1. For laser machines, there should be setting for Z - at what level you should cut measure the part in Z axis. 2. Check all calibrations are in place and passing 3. Check resistor package setup in the software - all dimensions
Electronics Forum | Sat Jan 18 03:18:04 EST 2014 | smtspareparts
Should be too high temperature on somewehere on machine, 1 Check cooling oil tank, If the cooling oil need replaced? Check the radiator of cooling tank, withdraw the filtering net and clean it,and clean the dust off the radiator of cooling tank wi
Electronics Forum | Tue Mar 29 04:15:01 EDT 2011 | ravo
Dear All, Thank you so much for your cooperation. Actually am in continous problems with my BGA and can not assemble it using my QP242 till now, I am using the following data : Vision no. : 1 Vision Type: 230 Height: 2.32 Body Size X: 27.00 +-0.
.gif)
