Electronics Forum | Thu Mar 28 19:36:21 EDT 2024 | linux
ensure the nozzle is inserting fulling into the nozzle holder. ensure shaft is lubricated, clean between the magnetics on the shaft. complete nozzle height calibration
Electronics Forum | Mon Jan 19 15:33:49 EST 2004 | J Smithj
We were and still are having problems with magnetized nozzles on the HSP 4796. The problem was found when numerous parts were thrown after being placed on pad. It appeared to be picking parts up off the board after placement. Nozzles were pulled out
Electronics Forum | Tue Jun 10 23:06:28 EDT 2014 | demzvill
In our assumption also, nozzle is magnetized because the chip termination is made up of alloy so possibilty that when there is excessive contact between two metals there magnetic field produce, so during z up chip is magnetize on the nozzle causing i
Electronics Forum | Mon Jan 26 09:42:20 EST 2004 | kauer
Any luck with the Nozzles?
Electronics Forum | Thu Sep 01 10:22:01 EDT 2005 | cmiller
We change the nozzles depending on the job. Do you have the magnetic nozzles? We upgraded to that. Usually we use the smaller ones.
Electronics Forum | Tue Jan 20 08:42:09 EST 2004 | Primus
We have four 4796 machines, and I have not yet seen this problem. By chance did You check to see if the Nozzle Storage Plate is magnetized? Just a thought. Hope this helps.
Electronics Forum | Fri Jan 23 13:17:59 EST 2004 | Gabriele
Make sure chips (some Resistor contain nickel,or A-42 (Fe-Ni)leads made like SOT-23, etc )some time they also are magnetized and get attracted by nozlles tips. rgds
Electronics Forum | Fri Nov 04 15:16:09 EDT 2016 | mmjm_1099
Couple things here that could be the caused. Option 1: Error pass, Option 2: Vacuum release issues, Option 3: Magnetized nozzles (I have seen this occur by purchasing cheap nozzles), Option 4: Dirty Nozzles. Currently have two CP43 and one CP42 that
Electronics Forum | Mon Jan 26 21:28:55 EST 2004 | Dean
If this is in regards to the manufacturing floor: I can remember years ago I had an Fuji IP3 + MTU4. Used square magnets to hold tray stacks square to the machine. Manufacturing manager told me they should not be used. Apparantly the magnetic fie
Electronics Forum | Tue Aug 02 11:58:44 EDT 2005 | GS
Are the pick up nozzles metal made (ironmagnetic material)? Some time magnetic residual on metal nozzles can generate pbm like that when chips terminations have nickel and when SOt or similar packages have terminal A42 alloy made. Time ago got pbm l
