Electronics Forum | Fri Sep 06 10:27:42 EDT 2013 | nophsem
Hi bobpan! MOD CODE 69 is "Waffle Tray Handler Installed Flag" and default setting 0. That's what mode code quick reference table says (the reference table that I've to respect according to the previous owner). And it's different what manual says (M
Electronics Forum | Tue May 10 07:57:49 EDT 2011 | mosborne1
Are you uploading the mod codes to your central controller when you change them? If not when you run your produciton the central controller will download the mod codes that are stored in the CC. You might also have an encoder problem. When the machin
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L
Electronics Forum | Wed Oct 10 12:56:26 EDT 2018 | bobpan
ya.....i forgot about that........ mod code 35 and mod code 36 control lighting on the machine. Full brightness is 255. There are also light setting in the configuration file but i tend to keep people out of it. Thanks, Bob
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Mon Oct 27 09:12:54 EST 2003 | roger_h
I've modified the Flexa feeder reports. I sent you an Email.
Electronics Forum | Wed Aug 10 12:22:09 EDT 2005 | jh0n!
Configuration>Parameters>Board Handling "Board stop mounted" was incorrectly checked. Mods, feel free to delete.
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Thu May 11 07:02:59 EDT 2023 | smtusa
So the MY series spec sheet mentions it under * footnote
Electronics Forum | Tue Oct 01 11:56:57 EDT 2013 | bobpan
I would try the following: 1. Back up your mod codes or make sure they are up to date. 2. Turn off the machine and slide a business card between the battery and the clip located on the EPCU card in the front card rack. 3. Download back in your mod co