Electronics Forum | Thu Feb 04 04:16:56 EST 1999 | Joni Siipola
I'm researching SO-8 power RF device mounting methods. Possible mounting method 1. Via thru holes Still the thermal resistance of the PCB too high Do you have suggestions for mounting the component, PCB/?
Electronics Forum | Tue Sep 01 14:11:27 EDT 1998 | Matt
How would you mount a surface mount chip onto Perf board? I am doing a project for school and one of the chips is a surface mount, but everything else fits in Perf board. Any suggestions? Thanks
Electronics Forum | Tue Jan 08 14:51:11 EST 2002 | edmentzer
The only time we had this problem was when the operator let the mount tool test position on the board be a mounting hole so the machine did not know where the board top was. You might want to check the mount tool position as a lot of PCB CAD people
Electronics Forum | Mon Jun 05 14:09:30 EDT 2000 | RFM
Hi everybody, could someone tell me what does it mean the term "Straddle Mount"
Electronics Forum | Wed Aug 11 02:21:07 EDT 2010 | mbulelo
Hi All Is it advisable to vertically mount PTH componets and if so, which direction is most suitable
Electronics Forum | Tue Dec 21 17:11:18 EST 1999 | Pascal G
Hello guys , we just started first trials on PTH connectors mounted in SMD. Our first results show big deviation of solder filing in the hole and also a dramatic decreasing of mounting spped on pick & place equipement. 1 - Did someone uses proflow
Electronics Forum | Thu Feb 04 20:31:10 EST 1999 | Dave F
| I'm researching SO-8 power RF device mounting methods. | | Possible mounting method | | 1. Via thru holes | | Still the thermal resistance of the PCB too high | | Do you have suggestions for mounting the component, PCB/? | Joni: What is it ab
Electronics Forum | Thu Jan 20 19:45:20 EST 2005 | yohelyav
We are looking for news on new or used Surface Mount Machines to buy, rent or lease. We want an assembly circuit board machine: Making circuit boards Important: * must have and be able to run surface mount machines. * load reels
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Mon Nov 10 19:34:20 EST 2008 | snsmt
Hello all, As you know, i have slowly begun programming the philips topaz-x machine. For one board that i programmed, everytime i place a board threw the machine, the parts mount differently everytime. The part that I am trying to mount is an ind