Electronics Forum | Thu Feb 10 08:25:02 EST 2005 | marakas
Could anyone advise what BGA rework rate we should expect with product that has 4 BGAs (224 pins, 196 pins, 160 pins, 48 pins). Negative factor is that we have old and tired pick & place - Panasonic MPA-G1 or MPA-V without AOI.
Electronics Forum | Thu Feb 19 22:58:40 EST 1998 | George Henning
We have some extra feeders that are used on a MPA 10 and MPA 80. I don't know if they are compatible with the machines you mentioned. If you find that they are and have a list of requirements, I'll find out what we can provide you. Regards. | HI, do
Electronics Forum | Mon May 16 11:10:26 EDT 2005 | wizy
I look also for new job in SMT area. Machines what i know: MPM APHie paste printer Simens lines (S23, F5, HS60 etc.) Panasert lines (MV II F, MPA-V, MPA G1, HDP) Omniflow reflow soldering Macrotron and Baasel laser engraver PDT3000 PROM programer
Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go