Electronics Forum: mpm problems (Page 1 of 37)

mpm ultraprint3000

Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx

hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w

mpm up 3000 ultraflex

Electronics Forum | Sat Jun 13 13:51:44 EDT 2015 | tnisbet

The problem could be the tactile motor, we have it in stock. Please contact sales@goppm.com and request a quote for part number CA-399.

speedline mpm UP-100

Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292

I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""

mpm up 3000 ultraflex

Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery

Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T

mpm up2000 backdoor?

Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH

I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr

mpm up 2000 camera problem

Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97

Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a

mpm up 2000 camera problem

Electronics Forum | Tue Aug 15 12:02:55 EDT 2006 | pr

Check your gel flex. They're no good. Don't use em. good Luck pr

mpm up 2000 camera problem

Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks

Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma

mpm up 2000 camera problem

Electronics Forum | Tue Aug 15 09:40:43 EDT 2006 | SWAG

Not sure about 2020 but AP's have an option to perform a histogram test/adjustment on the lighting. It's a black card, white card test and you can adjust a pot. in the machine to make the histogram curve "best-fit". On an AP, you find this option i

mpm up 2000 camera problem

Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin

Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa

  1 2 3 4 5 6 7 8 9 10 Next

mpm problems searches for Companies, Equipment, Machines, Suppliers & Information