Electronics Forum | Mon Jul 07 00:45:39 EDT 2014 | comatose
If you study how the process is done now, it isn't that different from what you describe. Instead of glue, we use solder paste, and instead of spraying it we screen print it. But not that different. For feeding boards we use conveyors instead of rubb
Electronics Forum | Tue Feb 08 23:29:54 EST 2005 | mrduckmann2000
Help! Does anyone know how to get a Camolot Gem II machine to put down dots for 0402 placement? I have been working with Electrovert Tech's that say their machine WILL place dots for 0402's. I have reduce the speed of the pumps to half the speed,
Electronics Forum | Mon Sep 21 04:23:16 EDT 2009 | smtbox
R series Features FCS (Flex Calibration System) highly regarded easy maintenance just got even easier! The optional FCS calibration jig is a simple to use system to re-calibrate placement accuracy. The machine automatically picks and places jig comp
Electronics Forum | Mon Jan 18 02:49:03 EST 2016 | nirmex
1-Machine speed. 2-New Head H24 and DYNA Head. 3-New Feeder type W08f 4-New Part Camera. 5-New Y-Axis Flat cable design. 6-New GUI with Touch Screen. 7-Panel Height detection. 8-Feeder raising detection. 9-NPI tools support. 10-Overall machi
Electronics Forum | Wed Oct 26 14:20:41 EDT 2005 | TPM
Brian, We have the Mirtec Table Top. It is very good at detecting the component and orientation. It is however only as good as we program it to be. We have seen some limitations in respect to solder connections. I have not found it to be 100% re
Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
Electronics Forum | Wed May 25 17:58:07 EDT 2011 | rssimmons
The SimmScope is a first article inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator to
Electronics Forum | Fri Jul 23 14:17:55 EDT 1999 | Steve Schrader
| | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performin
Electronics Forum | Sat Jul 24 00:04:55 EDT 1999 | Scott McKee
| | | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not perform
Electronics Forum | Mon Feb 16 12:33:58 EST 2015 | ianatvadatech
Hey Syed, I've been running the MV-9 for just over a year. We shopped around very extensively (two APEX shows) before switching from yestech to mirtec and we bought two of the best systems they had to cover the four lines we run. Two systems are fa
.gif)
