Electronics Forum | Wed Jun 01 14:58:45 EDT 2016 | claudea2
I answered my own question. The nozzle changer was in the left front, moving it to the left back fixes the problem.
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Tue Sep 05 11:09:09 EDT 2017 | emeto
The message might still be correct. Change the pneumatic cylinder on the nozzle changer - I have seen these to go bad.
Electronics Forum | Fri Sep 01 09:54:02 EDT 2017 | gsmx4321
I get a Timeout waiting for nozzle changer vacuum buildup failure every time I go to run my 1998 GSMx machine. The problems seems to be that once in a while (it seems to be random) the spindle does not line up exactly in the center of the nozzle cha
Electronics Forum | Tue Sep 05 10:14:41 EDT 2017 | swag
Try a fid teach on your changers. I don't recall how to do it but you'll find it pretty easy if you surf around. Also, the seals on the nozzles must be good and soft. If you can still get them new, I'd replace. Same goes for seals in changers. C
Electronics Forum | Fri Sep 08 22:37:30 EDT 2017 | ttheis
If you have two changers and only one head, make sure there is only one open port (one changer should be filled up and the other should have one open hole.) The head should be full of nozzles as well. As you mentioned go into the diagnostics and act
Electronics Forum | Tue Sep 05 14:40:08 EDT 2017 | rgduval
We emailed off forum about this...and I'm wondering how things are progressing. As I noted in email, our issue was the nozzle change was resulting in too many nozzles being out of the same vacuum channel on the tool box. I can't remember how it was
Electronics Forum | Tue Apr 19 10:09:33 EDT 2016 | swag
Try a nozzle changer teach. Machine will look for fids on the changer block. If that doesn't work, clean the rubber seals in the bottom of the block. No alcohol - dries them out. Might need to replace them if they are dry or cracked. Clean your
Electronics Forum | Tue Apr 19 12:38:00 EDT 2016 | ttheis
Looks like that did it; I put another nozzle in hole 5, set the configuration and machine dry-cycled properly.
Electronics Forum | Wed Apr 20 10:16:21 EDT 2016 | ttheis
Yeah, I think it has to do with both changers being owned by the one head. If each changer was owned by separate heads then they would each need an open hole.
