Electronics Forum | Wed Mar 12 12:28:52 EDT 2008 | operator
I recently witnessed a process in which the solder pot operator used Techspray WSOL water soluble masking to cover the areas around a connector that was to be soldered on the solder pot. He did not wait for the WSOL to cure. He soldered immediately.
Electronics Forum | Thu Feb 07 14:58:08 EST 2008 | operator
We don't have one of those cool air compressed syringes to dispense adhesive. We have to do it by hand. My question is does anyone have any suggestions on syringe size, needle size etc... for successful deposition of SMT adhesive? I know you can go s
Electronics Forum | Wed Mar 12 16:30:45 EDT 2008 | operator
I witnessed this at our sister company. It seems to be their standard process. It is not my place to interfere with their processes. I was just curious if there was any chance of brittle solder joints or other defects that might be caused from the WS
Electronics Forum | Fri Mar 14 11:18:29 EDT 2008 | operator
The way it works is the liquid solder immediatley cures (or should I say burns) the WSOL where ever it touches it. This hardens and keeps it in place and protects whatever is under it. Some of the WSOL falls of in the pot. I am suprised that the burn
Electronics Forum | Sat Jul 19 12:22:55 EDT 2008 | operator
Are there any softwares OR functions inside of the softwares that allow a designer that is creating a very large complicated wiring diagram with say....many terminal blocks and connectors etc... to run a point to point check on his drawing? Bascially
Electronics Forum | Fri Jan 24 16:57:39 EST 2003 | MA/NY DDave
Hi, I will give just one of the couple of ways I have seen. Once a particular product is debugged, verified through the process the profile of the Oven and it's settings are stored on a separate PC. Prior to running that product and at the start of
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Fri Jul 23 10:47:31 EDT 1999 | Mark D. Milward
There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing th
Electronics Forum | Fri Mar 04 10:57:20 EST 2005 | mrduckmann2000
Success! The exp worked very well. Now comes the fun of having a stencil built for the masking operation.
Electronics Forum | Thu Mar 03 09:04:26 EST 2005 | russ
Been following this thread and have a question, Why do "touch-up" people follow different criteria than "Q.C." people. It sounds like the root of the problem is not addressed but bandaids are being put into place. We have no "Q.C." department and