Electronics Forum | Mon Dec 29 09:37:25 EST 1997 | Craig Wilmer
| Can anybody give me feed back on the pro and cons of | using Pace, OK, Hakko, Metcal, etc... Kris, Pace is going to be your best bet when it comes to productivity. I used to do rework and repair for Compaq and all of the PCA lines in their manufa
Electronics Forum | Wed Dec 24 22:46:58 EST 1997 | Scott McKee
| Can anybody give me feed back on the pro and cons of | using Pace, OK, Hakko, Metcal, etc... equipment in | their rework processes? I need to set up a low volume | rework station for mixed technology boards. | Would appreciate any suggestions. I
Electronics Forum | Fri Dec 19 11:32:46 EST 1997 | Kris Ganev
Can anybody give me feed back on the pro and cons of using Pace, OK, Hakko, Metcal, etc... equipment in their rework processes? I need to set up a low volume rework station for mixed technology boards. Would appreciate any suggestions.
Electronics Forum | Wed Mar 10 13:04:10 EST 2004 | jpa
I need to purchase a rework tool mainly for QFP's including 30mm x 30mm. I was looking at a Metcal QX2 and a Pace TF200. I would welcome any comments on these two products or any other suggestions. Also, is a preheater necessary?
Electronics Forum | Thu Mar 11 11:34:09 EST 2004 | babe
The Metcal will run you around $5,000.00. The Pace is over $6,000.00. Check out Hakko model 852/853 for under $2,000.00 If your in the NewEngland area call us we sell them also.
Electronics Forum | Sat Aug 15 07:56:16 EDT 1998 | Clyde F.
| | We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. | Thx for any information | Best Regards, | Stoney Tsai PACE just came out with a new s
Electronics Forum | Wed Jul 22 13:57:03 EDT 1998 | bill
| | We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. | Thx for any information | Best Regards, | Stoney Tsai If you are doing any reballing
Electronics Forum | Thu Jul 12 20:58:30 EDT 2001 | davef
ERSA and PDR Xytronic both make very respectable lower priced rework equipment.
Electronics Forum | Tue Jun 15 15:10:44 EDT 2004 | mrmaint
Looking for feedback on an Airvac DRS24C Bga rework station. Looking for both good and bad feedback. Users only please, no sales folks. Thanks MRMAINT
Electronics Forum | Thu Jun 08 06:08:06 EDT 2000 | jacqueline coia
Hi There, I know this is a long shot but does anyone in Scotland have a 31mil nozzle for an Airvac rework station that they are willing to hire out for a short period of time? Also is there any papers or sites that can give good technical advice on B