Electronics Forum | Sat Jan 14 13:18:37 EST 2006 | mrduckmann2000
Let's think about this, there former filed service engineers. I bet they got out of field becasue of being laid-off. Typically the NON-Performers are the first to go. Hint hint.....former field engineers! Quad 4C's when they were new to the marke
Electronics Forum | Thu Jul 20 14:57:26 EDT 2000 | Bob Willis
I have just measured my new test board and the dimensions are 0.025� square, 0.015� seperation with resist aperture 0.004� larger. Don�t know when I will be using it yet. I have not seen a head to head with these pastes yet, I know that Panasonic ar
Electronics Forum | Fri Mar 24 15:40:23 EST 2006 | Gilligan
Novemer 13, 2001, minutes from the JG-PP Lead-Free Solder project: http://www.jgpp.com/projects/lead_free_soldering/minutes/01novminutes.pdf It seems to me, that although everything was discussed before hand, it wound up being the "Let's do it and
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Wed May 25 23:45:04 EDT 2022 | SMTA-64387687
1. The jetting head flies very low to the level of the board. So, performing AOI function will crash the head. 2. AOI is performed close to the end of the line, after P&P or reflow. Are you planning to run the boards back-and-forth, on the line? 3. L
Electronics Forum | Mon Aug 29 11:39:23 EDT 2016 | tdemon69
I was wondering if you could help me with my Panasonic MV. it is throwing parts around after it picks them up . only have 3 heads work in it.
Electronics Forum | Mon Aug 29 13:34:58 EDT 2016 | mhanrahan
We had this issue with our old MV 150. This was usually due to clogged/dirty or bent nozzles, or clogged dirty filters on the vacuum supply to the head.
| 1 |
