Electronics Forum: param (Page 1 of 1)

Guidelines for Cost Determination

Electronics Forum | Mon Jun 18 11:15:53 EDT 2001 | Gil Zweig

The cost of an x-ray inspection system will be determined by the following inter-related paramers: 1. The focal spot size of the x-ray source. 2. The maximum tube voltage. 3. The physical size and shielding requirements of the systems. 4. The design

Wave soldering defects

Electronics Forum | Thu Dec 29 10:47:22 EST 2016 | luciano

Thanks SuMoTe, I've already tried fluxing various boards (new clean ones and older ones) without turning the waves on and with different temperature setups (within the suggested params from Alpha) in the preheat zone. The results were in many cases

QUAD IVC Pickup Problem on Z Axis

Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette

Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and

quad 1000 error

Electronics Forum | Mon Jun 13 19:07:57 EDT 2005 | bobpan

Mike, Right down all the settings you have for your machine (this may take a while). Also back up the programs you want to save. Now....if i can remember correctly.....when looking into the black computer box from the back of the machine...in your bo

  1  

param searches for Companies, Equipment, Machines, Suppliers & Information