Electronics Forum | Mon Aug 31 06:26:44 EDT 2015 | piyakorn
Hi At our SMT mounting found battery clip stick in the reel pocket and some dropped under pick&place machine from the nozzle can not pick out the part which got recommendation should change the nozzle type from standard placement to be clip sho
Electronics Forum | Mon May 20 15:19:50 EDT 2013 | smtventasmex
i been trying to do that with a lot of my customers but they can not clean that well it works for just one time but you have to remember than this parts are platic, and will have some damages, i can sell to you quality nozzles at the best price on th
Electronics Forum | Tue Mar 01 03:25:33 EST 2005 | bing
We are using a GDM with a linear piston pump fitted to dispence adhesive on 0603's. Use Universal part number 43273801 needle with a 42346504 piston. The single needle dimentions are 0.010 ID, 0.028 OD, 0.005 stand off
Electronics Forum | Sun Feb 16 02:39:18 EST 2020 | originoat
panasonic kme nozzle dust filter original part PN 010DC181502
Electronics Forum | Tue Apr 05 12:03:39 EDT 2022 | my3sons
Hello, we can offer you a great solution for handling these LED's which I'm betting are sticking to the nozzle after placement correct? We use a special tip material that doesn't stick...our part # 2014-2146 $450.00
Electronics Forum | Tue May 05 08:32:34 EDT 2020 | travishemen
Check for nozzles that are stuck up. They may be able to pick the part but will drop the part during placement. I have also seen a feeder several positions over from the part not being picked/placed have a piece of carrier tape sticking up and not
Electronics Forum | Wed Aug 23 09:27:41 EDT 2017 | dleeper
As Evtimov mentioned, it will be dependent on package. It will also be dependent on the specifics of your machines so there is no universal "good" value. You will need to experiment to find the best values for your equipment and components. I would
Electronics Forum | Thu May 07 10:48:07 EDT 2020 | greezmky
Yeah my post disappeared as well? I checked to see if there was an offset and there was not. I tried step mode and all was good. I DID get to capture one video in, slow motion, and it shows the part being placed, the nozzle rising, and then when
Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Fri Sep 19 14:53:47 EDT 2014 | cyber_wolf
Did you buy Juki nozzles and parts ?
