Electronics Forum | Tue May 15 15:15:53 EDT 2001 | ohboy
Hi all, I just discovered this forum and I'm very impressed. We have a vendor who recently stopped placing desiccants in the vacuum packaging for our pcbs. (Yes, it's on the dwg!) His reasoning was that the desiccants can degrade the finish on the
Electronics Forum | Wed May 16 08:48:12 EDT 2001 | ohboy
I been a bunch o' places...! Some good, some bad, re-inventing the wheel in many cases. Our specs are pretty specific in a lot of cases, but that doesn't mean they always get followed. It usually becomes a case of "It's not quite right, but we rea
Electronics Forum | Tue Nov 01 12:28:36 EDT 2016 | comatose
It depends. Are you hand breaking them, rotary knife or linear knife? Hand break you want to be about 5mm (and it isn't a great practice even then) with a rotart knife you want to keep parts probably 3mm, especially capacitors. With a linear knife we
Electronics Forum | Mon Feb 19 11:36:39 EST 2001 | billschreiber
Hello Mark, I wish it were that simple so I could direct you to a particular manufacturer and stencil cleaner model. Unfortunately, there are several issues complicating the process of cleaning all these applications in one machine. First and fore
Electronics Forum | Thu Feb 10 09:01:40 EST 2005 | russ
I have done that also, It does work well. One issue we had was that the mask didn't come right off during the first wash cycle since it was put on much heavier than the mfgr suggested (.01"). We had to soak them in some water first to soften it up
Electronics Forum | Wed Feb 09 21:19:03 EST 2005 | Mrduckmann2000
Russ, We can not use a wave pallet, already went that route. We have parts next to the thru-hole pins and between thru-hole pins. I am going to try an experiment in the next day or so with solder mask. I plan to solder SMT parts on the back of se
Electronics Forum | Thu Jun 22 00:16:24 EDT 2006 | Gman
Hello, Has anyone had issues with voiding while using Imm Silver PCB finish. Does thickness of silver, contamination of the plating bath or other factors if you come point out cause voids due to the plating.
Electronics Forum | Thu Jul 06 12:06:12 EDT 2006 | pavel
Rob, do you have any tip on reliable supplier of "really flat" flexible pcb? We tried several but all with issues. Thank you. Pavel
Electronics Forum | Tue Sep 29 10:53:42 EDT 2015 | marlyn
Hey there fellow people with SMT issues... What's the proper procedure for soldering through-hole headers on the back-side of the PCB (pins poking out on same side as SMT parts)? ( Yes - I did the SMT side first and am now faced with LOTS of pin-poin
Electronics Forum | Tue Nov 28 21:16:17 EST 2006 | davef
J Rose at EMPF says: The introduction of no-clean solder fluxes in electronics manufacturing has given rise to greater levels of solder balling simply because the opportunity to remove them in the wash process does not exist. They are typically cause
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830