Electronics Forum | Mon Mar 22 07:40:01 EDT 2010 | emanuel
Are you absolutely sure the problem is with the humidity? We had a problem with 3528 size leds, damaged by the pick and place nozzle because a 0.2mm mistake in the height measurement. Also, we found that several suppliers are using fake desiccant ba
Electronics Forum | Fri Aug 02 11:45:26 EDT 2013 | garyck
Need to pick between an inexpensive Manncorp manual axial lead former or the Manix unit. Any one have any experience with either of these two units?
Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
Electronics Forum | Mon Aug 27 08:37:13 EDT 2012 | rgduval
If you're still having this problem, talk to Al at MyData about replacing the ribbon cable that is wrapped inside the head, and connected to the two LED's. It's a bit of a pain to replace this cable, but, it did fix the problem for us. The other po
Electronics Forum | Tue May 13 08:47:38 EDT 2008 | locostpp
Yes, this is a good point and really only time will tell just how reliable such a machine becomes. What I'm aiming for is to simplify and reduce the number of sub-assemblies. For example we are building the camera/vision processor and lighting into
Electronics Forum | Wed Nov 13 15:05:48 EST 2013 | jimmyboz
With what machine? I cannot help until that is disclosed.
Electronics Forum | Wed Nov 13 15:33:08 EST 2013 | mondalaci
Good question :) I'd say with a machine that is available for an average pick and place operator nowadays. Our manufacturer is not fixed yet, that's why I don't have any specific. On a related note I'm wondering whether the machine is so importan
Electronics Forum | Tue Nov 12 17:11:32 EST 2013 | mondalaci
Hi Folks, I'm working on a LED display that is composed of multiple layers. What is interesting for the point of this discussion is the PCB layer and the light deflector layer on top of it. Please take a look at the related pictures at http://plus
Electronics Forum | Wed Nov 13 16:48:19 EST 2013 | spoiltforchoice
I would expect any half decent machine to place 0603 parts slap bang on target to the typical defined accuracy for such parts on most machines of perhaps ~60 microns or better. Self correction during reflow is IMHO much less pronounced with lead-free
Electronics Forum | Wed Apr 28 17:45:41 EDT 2021 | mishafockin
Flexibility (if what I am thinking about flexibility is correct) is more important than speed. Most of the time spent on reloads, not the runs. We have high mix and fairly low volume (100-1000) Medium complexity QFPs, 0402, LEDs 100-2000 components p