Electronics Forum | Sun Mar 28 18:49:36 EDT 2021 | mekmat544
Hello, I would like to ask you if there is some formula how to calculate PTH hole and annual ring for pin in paste technology? Thank you. Mekmat.
Electronics Forum | Thu Jun 10 19:10:05 EDT 2021 | kojotssss
Hi, Get your account. https://software.indium.com/stencil-coach/pin-in-paste-apertures.php
Electronics Forum | Fri Nov 08 14:19:59 EST 2019 | dwl
You can try putting titanium stiffeners on the PCB to prevent it from warping. How thick is your stencil? More paste would give you a wider window however too much and you risk bridging. You could try over printing the pad at the heel and toe to get
Electronics Forum | Thu Nov 07 21:28:31 EST 2019 | sssamw
The connector is so long, and has big metal parts, it will be little deformed during reflow I guess, andthe pins planarity should be critical for 200 pins. Did you measure the non wetting pins profile to see if temperature ok? And maybe you can try u
Electronics Forum | Sat Feb 12 09:08:47 EST 2000 | Sal
Experiencing a problem with a 208 PBGA device. I am achieving good wetting with the exception of one ( damn) pin on the outer corner.I have a really good profile but the worrying thing is that it is so inconsistant. Once this open pin failure is dete
Electronics Forum | Sun Feb 13 01:35:55 EST 2000 | Dean
Without further information my first guess would be lack of flux to "cut through" the ENTEK layer. Question: In X-ray is the suspect ball of equal diameter when compared to adjacent balls? If no then the volume of solder is different which would po
Electronics Forum | Wed Mar 14 12:06:15 EDT 2007 | Oswaldo Rey
There is an approximate 1W dissipation and has a 2 sq in area below part on solder side as a heat sink, vias are to physically conect this solder side area to power pad, so its necessary to use an adequate amount of paste. I really don�t think it has
Electronics Forum | Fri Nov 08 05:40:54 EST 2019 | leeg
We place these on a few boards and have no issues with reflow or warpage. How thick is your PCB?
Electronics Forum | Tue Jul 20 06:36:24 EDT 1999 | Badia
First of all, I'm a young Spanish so sorry for my English I'm looking for a smd single pin connector. I need it to solder it in a alumina's substrate. Please. can anybody help me ?
Electronics Forum | Mon Jul 26 13:39:26 EDT 1999 | Badia
Despite the goodness of Dave F. and George Verboven, I was unable to find the damned single pin connector. As a last attempt, I've draw it (see the link) If somebody knows where can buy it, please help me (and sorry for to ruin the English language
WINTECH provides new/used/pre-owned SMT, AI & PCB Assembly (PCBA) equipment of various brands. Also supply service, modification & original or local-made spare parts. We are also an appointed agent for well-known brands.
Equipment Dealer / Broker / Auctions
NO. 1 LORONG SAGA JAYA 6
PERAI, Malaysia
Phone: 6043809899