Electronics Forum | Thu Jul 01 20:47:48 EDT 1999 | Scott McKee
I called a new customer today and told him that one of his parts on the proto boards (a capacitor with a polarity 'tit') was too long for the pads and the pads were small causing the end opposite of the "tit" to lift up. I suggested that the product
Electronics Forum | Sat May 28 15:57:54 EDT 2005 | lupo
Usually reffer to polarity of capacitors (-, +)
Electronics Forum | Sun Aug 25 19:22:20 EDT 2013 | action_101
What does your software do for providing component polarity in a reference guide?
Electronics Forum | Thu Jul 10 03:51:54 EDT 2014 | sundarmanik
I want know how to give polarity in NXT Fuji Flexa .Kindly help on this . Given some picture & option
Electronics Forum | Fri Aug 08 16:55:20 EDT 2008 | thaqalain
On a specific shop order we face the trouble of wrong polarity for LINEAR VOLT REG. This is happened b/c components were situated diagonally opposite way in the reels. Here are suppier details: ST MICROELECTRONICS P/N: L5973D013TR Can we leave b
Electronics Forum | Wed Jul 24 16:12:39 EDT 2013 | tbouslog
I am looking for a poster (or anything) that shows Polarity Markings for different SMT Components. I would like something for SMT Operators and SMT Setup to be able to look at when training or when they are questioning the polarity of a part. If anyb
Electronics Forum | Thu Jul 30 16:50:41 EDT 2015 | lokit
In our production line we use the pick and placer My100 by Mycronics. We get a lot of feedback from quality department about IC's being placed upside down, wrong polarity. (Wrong polarity usually already delivered to us, or IC's placed in the sticks
Electronics Forum | Tue May 28 08:31:49 EDT 2002 | Hussman69
Hello, I know I will probably get a dozen "check the archives" answers, but what the heck. What is YOUR typical polarity mark for SMT devices? Do you use silk screen or cut a corner off a pad? Let me know and thanks.
Electronics Forum | Wed Jan 14 14:58:21 EST 2004 | Gilroy Misquita
I would like to know if there is an International standard for BGA and QFP polarity in trays for pick and place. How are these components placed on trays and is there a polarity of the tray itself? Please feel free to send me an email or reply on t
Electronics Forum | Thu Jan 15 12:55:03 EST 2004 | James
Polarity in tape and reel is usually always on the bottom left side. And that is correct for the trays, they have a corner taken out where the polarity goes. Hope that helps........
.gif)
