Electronics Forum | Tue Mar 07 08:48:55 EST 2006 | samir
Our ICT Guy here at my company loves to use lots of via holes as test points - via holes which are 0.040" diameter, and spaced at 0.004" edge to edge spacing! He doesn't like to tent the via's either, so I always battle via-to-via shorts at the wave
Electronics Forum | Tue Mar 07 21:35:16 EST 2006 | Cal Kolokoy
Samir, From experience, the only board test situation where tented via's have difficulty with contact is with a Flying Probe type tester. Otherwise, for traditional ICT, the force of the pogo pins, correct probe type, and fixture design should do th
Electronics Forum | Fri Apr 27 10:55:54 EDT 2007 | Brett
Pete, is there a probe-style that will accomodate a via that's filled, but a little concave (inward) fillet? The ICT personnel complains about this scenario too. I'm not an ICT person, but I do know that there are pogo pins that have a crown (for t
Electronics Forum | Fri Apr 27 08:44:08 EDT 2007 | Brett
For those of you who use via holes as test points, and the via holes must be filled at the wave, is it necessary to have a "dome" on every single test point, or is it sufficient to have the via "filled" with solder? The ICT preson here insists that
Electronics Forum | Fri Apr 27 10:38:30 EDT 2007 | pjc
No dome needed. You should check what type probe you have. You can look here and consult with them: http://www.qualmaxamerica.com/qualmax/leeno/semi.asp?string=ICT
Electronics Forum | Mon Mar 02 23:48:22 EST 2015 | vb7007
Hi We are using Universal carrier for a 2 sided PCB, where the bottom side goes for hand solder the switches after wave. Our issue is, we are getting micro solder balls all over PCB bottom after wave, whereas we got numerous vias, which also turns
Electronics Forum | Fri Jan 30 10:29:48 EST 2009 | petep
We have a potential new customer who has special PCB requirements. I do not know a lot of details at this point, but have several questions. One of their assemblies has within it , a MID, Solid foil layer, completely isolating one side of the PCB f
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
| 1 |
.gif)
