Electronics Forum | Thu Jul 26 14:55:17 EDT 2001 | mparker
Why not a stink bomb during regular work hours? (If you can get any methyl mercapton, that stuff is very odorific. Smells like baby's barf. A little dab'll do ya!) That way you could gage the complaint ratio as time goes by. Could save you much elbow
Electronics Forum | Wed Jun 26 04:00:30 EDT 2019 | SMTA-David
Thanks, I'll take a look. Something else I found was the Z height for the module was set to 1.7mm but I am picking up the part on the PCB surface which is only 1.0mm from PCB being loaded, therefore the part must have been let got 0.7mm above PCB an
Electronics Forum | Thu Nov 29 15:52:53 EST 2007 | jmelson
Some other machines are a lot simpler. Here's how the Philips (mady by Yamaha) CSM84 works. Smaller tape (8 and 12 mm) feeders are all mechanical. A plunger on the head pushes a lever on the feeder at the same time the head comes down. First, the
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Tue Apr 17 13:33:00 EDT 2001 | Kris W
Howdy all! Nothin' up my sleeve!!! While attempting to reflow an RF antennae on std FR4, HASL coated, using no clean paste, in a Research Thermaflo 10, the part sometimes slides on one of the pads (as much as 0.125"). There is a slight amount of w
Electronics Forum | Wed Jul 18 22:23:44 EDT 2001 | davef
First thing, I wouldn't buy new. There's tons of this stuff out there, the problem is finding the used stuff. One place to look is the SMTnet used equipment sales watteverzits called. Roland knows the name. Most work bench suppliers [eg, Arlink,
Electronics Forum | Mon Jun 07 12:22:44 EDT 1999 | Chrys Shea
| I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." The
Electronics Forum | Thu Mar 09 16:56:19 EST 2000 | Dave F
Ashok: If I was to count, I'd guess there was more than 4 subquestions. Hey, but who's countin' anyway? I have answer (s) "on ESD all related to use of wood in a typical PCB Assembly line:" Before pushing-on, it is only "a typical PCB Assembly li
Electronics Forum | Thu Mar 09 16:56:19 EST 2000 | Dave F
Ashok: If I was to count, I'd guess there was more than 4 subquestions. Hey, but who's countin' anyway? I have answer (s) "on ESD all related to use of wood in a typical PCB Assembly line:" Before pushing-on, it is only "a typical PCB Assembly li
| 1 |
