New Equipment | Rework & Repair Equipment
Patented Inductive-Convection Heating Technology Provides Ultimate Thermal Performance Conventional resistance coil heating technology has been successfully used in convective rework stations for decades to install and remove a variety of BGA, QFN,
New Equipment | Rework & Repair Equipment
Patented Inductive-Convection Heating Technology Provides Ultimate Thermal Performance Conventional resistance coil heating technology has been successfully used in convective rework stations for decades to install and remove a variety of BGA, QFN,
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Wed Apr 11 00:40:19 EDT 2012 | ngineer
I have a problem setting up the LAE on my Quad 4c. I set it up for 0805, and it seems to work, although it rejects a lot of parts, at least it places "most" of them. I tried setting up on a soic14, and could not get even one to pass. I believe I h
Used SMT Equipment | Pick and Place/Feeders
QUAD Pick & Place Model: 2C Serial Number: 2785 Quad 2C SMT Placement System Features: Placement rates of up to 3,600 cph Handles complex boards - with components from 0402s to 1.00" square The QuadAlign system provides automatic correcting
Used SMT Equipment | Pick and Place/Feeders
8mm, 12mm, 16mm, 24mm, 32mm, 44mm IQ ( Intelligent ) Surface Mount Tape Feeders and tape feeder reel arms for QUAD Q series and C series pick and place machines. These are the newer 8 pin, deep pocket, feeders and they will work on the newer intellig
Industry News | 2013-11-27 15:30:07.0
Martin introduced its new rework Process Shuttle that streamlines flux and solder paste dipping or printing, and pre-positions the smallest surface mountable devices (SMDs) for pickup. This enhancement to the company's EXPERT 10.6 rework system was designed to increase the efficiency and quality of the work performed.
Industry News | 2016-10-26 14:55:50.0
Vass, NC – Sept 20, 2016 – PACE Worldwide announces an introductory promotion in conjunction with the launch of their new TF 1800 BGA/SMD Rework System, which began shipping in October. For a limited time, PACE will provide 10 Heat Focusing Nozzles free of charge with the purchase of each TF 1800 System, a value of over $3,400 (£2,700/€3,340).
Enter PACE’s TF Series BGA/SMD Rework Systems. With its groundbreaking, patented Inductive-Convection Heating Technology, the TF Series top-side heater reaches the target temperature in just seconds for safe, rapid solder joint reflow in virtually an
Enter PACE’s TF Series BGA/SMD Rework Systems. With its groundbreaking, patented Inductive-Convection Heating Technology, the TF Series top-side heater reaches the target temperature in just seconds for safe, rapid solder joint reflow in virtually an