Electronics Forum | Tue Jan 30 10:43:18 EST 2007 | darburch
Before you do anything to the windmills check the heights in your PD's and if you are using board supports be certain that they are set correctly. The CP 65 has approx 1.8mm of travel before the pin will get stuck, as the nozzle should only deflect .
Electronics Forum | Mon Aug 12 18:26:05 EDT 2002 | pjc
If you are talking actual placement rate- from first fiducial read of board no. 1 to first fiducial read of board no. 2, here is the best I've ever seen based on the boards I've run: CP3- 141 seconds for 468 components per board (all rectangular chi
Electronics Forum | Fri May 24 11:49:55 EDT 2002 | stefwitt
Again, I would like to refer to the tape dimensions and their deviations. In an 8 mm tape the distance from the sprocket holes to the tape pocket is 3.5 mm +/- 0.05 mm. This tolerance is easy to achieve, because in the manufacturing process of the ta
Electronics Forum | Tue Jul 13 14:36:55 EDT 1999 | JohnW
| I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick. |
Electronics Forum | Wed Jul 14 09:56:54 EDT 1999 | Wolfgang Busko
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 19:09:54 EDT 1999 | JohnW
| | | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stic
1 |