Electronics Forum | Thu Jun 04 09:53:31 EDT 1998 | Dave F
| I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and
Electronics Forum | Thu Jun 04 11:09:50 EDT 1998 | Justin Medernach
| I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and
Electronics Forum | Thu Jun 04 09:29:21 EDT 1998 | Chrys
I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and r
Electronics Forum | Thu Jan 13 13:16:40 EST 2000 | Dave F
Tony: You have choices: * Hi Temperature Tape: Go with Wolfgang ... too tough to control. * Selective Soldering Pallets: Some like 'em some don't. A lot of your success depends on the pallet fabricator. * Screenable Temporary Solder Mask: Wol
Electronics Forum | Thu Jun 04 20:52:57 EDT 1998 | D.Lange
| | I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after a
Electronics Forum | Thu Sep 23 06:10:52 EDT 1999 | Wolfgang Busko
| | | Question for you SMT guru's out there. | | | | | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following meth
Electronics Forum | Thu May 07 21:25:56 EDT 1998 | D.Lange
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Sat May 17 09:42:10 EDT 2008 | realchunks
The Optimizer can be run through your wave like a regular board. It measures temps, times and parallelism of your waves in relationship to your board (pot to conveyor). Run the Optimizer till you get you temps, times and are parallel to your waves.
Electronics Forum | Tue Dec 29 17:42:27 EST 1998 | Dave F
| Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. | | The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. | W
Electronics Forum | Sat May 09 11:54:12 EDT 1998 | Bob Willis
All the comments that have been made a great but I do have to say that much of the problem comes back to the design engineers not designing for manufacture. Centre board supports would have sorted the problem without jigs. | | I am running a board t